Tunnel in 3 steps
-
Set the BTC amount and paste a Monero mainnet receive address — a fresh subaddress is recommended.
-
Create the order to lock the quote and see the BTC deposit address.
-
Send BTC on Bitcoin mainnet. After confirmation, XMR is paid to your wallet.
Before you broadcast
- One Bitcoin confirmation is usually enough before the XMR payout leg starts.
- Use a SegWit (bc1…) BTC send address if your wallet supports it — lower fees and faster inclusion.
- Use a fresh Monero subaddress for each swap. Avoid reusing old XMR receive addresses.
- XMR not visible yet? Allow your Monero wallet time to sync — incoming outputs can take several minutes to appear.
Bitcoin — the original digital asset
Since 2009, Bitcoin has been the benchmark cryptocurrency — deep liquidity, wide recognition, and the default on-ramp for cross-chain swaps.
Before you send BTC
- Confirm your wallet can send to SegWit (bc1…) addresses.
- Leave enough for a network fee — low fees mean slower confirmation.
- Send only BTC on Bitcoin mainnet to the address on your order page.
How long until Bitcoin confirms?
Block times vary with network load and your chosen fee.
- Use mempool.space or similar tools to check whether your fee is competitive.
- Explorers show queue position — compare against pending transaction volume.
- Average block interval is ~10 minutes, but longer gaps happen.
Why traders move BTC to other chains
Bitcoin offers deep liquidity and wide recognition — many swaps start with BTC as the funding asset.
Moving into Ethereum, stablecoins, or alt L1s lets you access DeFi, payments, or portfolio diversification without a custodial account.
Monero — private by default
Monero uses ring signatures and one-time addresses so amounts and addresses stay confidential on-chain.
XMR not visible yet?
Wait for wallet sync to complete — Monero often needs several minutes to reflect incoming outputs.
If the order lists a payout tx but your synced wallet shows nothing, contact support.
Receiving XMR privately
Monero payouts use one-time addresses — your wallet must finish scanning recent blocks to display the balance.
- Use a fresh subaddress for each swap rather than reusing old receive addresses.
- Compare your wallet block height with a public explorer before assuming a payout failed.
- Allow extra time after the order shows sent — privacy features can delay wallet display.
Before you swap
Avoid wrong-network deposits and address format mistakes — read these guides first.
Coin swap hubs
More no-KYC swap pairs and guides for each asset.
Frequently asked questions
Do I need KYC to swap BTC into XMR?
No. TunnelSwap runs an anonymous no-KYC, privacy-first swap — no profile, no ID upload, and no funded account for Bitcoin → Monero.
Why swap BTC into XMR for privacy?
Bitcoin is transparent on-chain; Monero uses default privacy features. Many users bridge BTC into XMR before holding or spending privately — always use a fresh Monero subaddress for each order.
How fast is a BTC → XMR swap?
Typical completion is a few minutes. Bitcoin usually needs one confirmation; Monero payout may take a few minutes to appear after your wallet syncs.
What address format should I use for XMR?
Use a Monero mainnet subaddress your wallet generates. SegWit (bc1…) BTC sends are recommended on the deposit side when your wallet supports them.